PTP
PMP
Parameter/Description
√
maxdst: Maximum distance to a subscriber [Km].
<distance>
√
√
maxtxpower: Enter the Tx power level (dBm).
This setting is for the transceiver output only. The actual EIRP depends on the
gain of the connected antenna. See section 7: Appendices for a list the
maximum transmit power setting based on the antenna gain for a series of
frequency settings. The maximum value for this field is determined by the
options key.
√
mgmtag: Management VLAN enable.
<mode>
√
mgmvid: Management VLAN ID.
<vlan_id>
√
mrate: Enter the maximum uncoded burst rate (Mbps). Entry values are
dependant on the channel bandwidth (chwidth).
The maximum value for this field is determined by the options key.
√
√
netmask: Enter the IP netmask.
√
√
optionskey: Enter the options key string.
<kIdx>
<kStr>
√
peermac: Peer MAC address.
<id>
<mac>
√
pllm: Enable or disable prioritized low latency mode;
√
√
radio: Enable or disable the radio transmitter.
√
ratedif: Enter the number of modulation levels to step down during re-
transmission of errored wireless packets. The level can be set from 0 to 7
(recommended value = 2).
√
regper: Frames number between registrations.
<frames>
√
√
rffreq: Enter the center frequency for the RF channel. When operating multiple
links in close proximity, channel frequencies should be separated by a
minimum of the channel size to minimize interference. For example, when
operating in with 20 MHz channels, the separation must be greater than 20
MHz.
√
√
snmp: SNMP enable setting.
√
√
snmptraplink: Enable or disable sending an SNMP trap message for each
link-up and link-down event.
<setting>
70-00072-01-07
Proprietary Redline Communications © 2008
&
AN-80i
Table 36: CLI - set
- Maximum distance from SC to SS [Km].
- [on | off]
- <VLAN ID>
10 MHz: 3, 4.5, 6, 9, 12, 18, 24 or 27
20 MHz: 6, 12, 18, 24, 30, 36, 48, or 54
40 MHz: 12, 24, 36, 48, 60, 72, 96, or 108
- Index of the options key [0 | 1]
- [<options_key_string>]
- [id number]
- <MAC address>
off - Disable
on - Enable
off - Disable
on - Enable
- The number of frames between registrations [4..100].
off - Disable the SNMP agent.
on - Enable the SNMP agent.
- [on | off]
User
Manual
Page 77 of 106
Sept 18, 2008