Redline RedCONNEX RedACCESS AN-80IE User Manual page 75

PTP PMP Parameter/Description
√ dfsaction: Select the mode of operation for DFS. The system set to master-
mode monitors for interference from radar devices and other equipment using
the same channel frequency. When interference is detected, the system
automatically takes the action selected using the drop-down menu:
<action>
None: The DFS function is disabled.
Tx Off: Transmission is immediately disabled when radar signals are
detected. This action is recorded in the message log and an SNMP trap
message is sent (if SNMP enabled).
Chg Freq: Relocate transmission to an alternative frequency immediately
when radar signals are detected. This action is recorded in the message
log and a trap message is sent (if SNMP enabled).
√ dlqos: Downlink QoS.
<id>
<qos>
√ dlrate: Downlink rate.
<id>
<rate>
√
dst: Enter the actual length of the path that the wave travels in order to
establish the link. Units are defined by dstmu setting.
This value is used to calculate the transmission-to-response interval and
disregard reflections of the transmitted signal. Used only if dstmod is set to
'manual'.
√
dstmode: Select the mode for determining the distance of the wireless link.
√
dstmu: Select the measurement unit for the link length (dstmode).
√
efw: Enable or disable the Ethernet Follows Wireless function.
When Ethernet Follows Wireless is enabled the Ethernet port status is
controlled to reflect the status of the wireless interface. When the AN-80i
detects that the wireless interface has failed (or is manually disabled), the local
Ethernet port is immediately disabled. The Ethernet port is enabled when the
AN-80i registers on the wireless link.
√
efwtimeout: Enter the period (in seconds) the Ethernet port will remain
disabled following loss of connectivity on the wireless interface. Following this
interval, the Ethernet port will be automatically re-enabled to allow
management of the AN-80i.
√
encmode: Enable or disable the encryption function.
If encryption is enabled, the correct encryption keys must be entered on both
communicating systems.
70-00072-01-07
Proprietary Redline Communications © 2008
&
AN-80i
Table 36: CLI - set
- [none=0 | txoff=1 | chgfreq=2]
- [id number]
- <QoS>
- [id number]
- <rate>
auto: Distance is calculated automatically by the AN-80i.
manual: Operator enters link distance.
mile - dstmode units are miles
km - dstmode units are kilometers
off - Disable
on - Enable
off - Disable
on - Enable
User
Manual
Page 75 of 106 Sept 18, 2008