Web Browser; Telnet Access; Install Options Key Upgrade; Figure 43: Configuration: Login Screen - Redline Connect Series Installation Manuallines

RDL-3000 Connect-OW-OW

Web Browser

Use the following steps to establish a Web session with the wireless terminal.
On the PC, open a browser and enter the unit wireless terminal TCP/IP address in
1.
the browser address bar. The default wireless address is:
IP:
Netmask:
Login to the wireless terminal using the assigned username and password. The
1.
default credentials are:
Username:
Password:

Telnet Access

Use the following steps to establish a Telnet session with the wireless terminal.
On the PC, open a Telnet client and enter the unit TCP/IP address. The default
2.
wireless address is:
IP:
Netmask:
Login to the wireless terminal using the assigned username and password. The
3.
default credentials are:
Username:
Password:
Note: If the IP address or username/password of the unit is unknown, refer to the RDL-
3000 Family User manual section 'Recover from Lost Password or IP'.
4.4.3

Install Options Key Upgrade

The default options key (2 Mbps) is installed at the factory. This procedure is required
only if additional features have been purchased for this specific Connect-OW system.
Use a Web browser to login to the wireless terminal. You must login as administrator.
1.
Click Utilities ->
2.
Enter a valid permanent or temporary options key in unused Options Key field.
3.
Important: Do not overwrite the default key from the factory.
Set the Active Options Key setting to the new key (e.g., Options Key 2).
4.
Click Activate to enable the new features. It is recommended to reboot the system.
5.
70-00200-01-00
Installation Guidelines
192.168.25.2
255.255.255.0
admin
admin

Figure 43: Configuration: Login Screen

192.168.25.2
255.255.255.0
admin
admin
Product Options
Proprietary Redline Communications © 2014
to display the Product Options screen.
Page 51 of 58 December 3, 2014