Table of Contents
Advertisement
16. Operating Instructions
16.1 sound signalization
signal
After pressing the "
short beeps
the panel.
Fire and/ or Fault operating mode. The signal can be stopped by
Continuous
pressing the "
beep
remains.
After pressing the "
Interrupted
zones/sounders and the "
beep
Man" test mode of zones. The signal can be stopped by pressing the "
16.2 service Modes
Zone Enable / Disable
Each zone of MAG8 can be enabled or disabled.
Z
To disable a zone:
• Press
ENABLE/ DISABLE:
• Press
TEST/ SCROLL, un-
til you reach the zone which has
to be disabled:
• Press
ENABLE/ DISABLE:
• Press
RESET:
Z
To enable a zone:
• Press
ENABLE/ DISABLE:
• Press
TEST/SCROLL, until
you reach the zone which has to
enable:
ENABLE/ DISABLE: The yellow LED of the enabled zone blinks.
• Press
• Press
RESET:
Fire Control Panel MAG8 - Installation and Operation Manual
SILENCE BUZZER" button, but the LED indication
SILENCE BUZZER" button, but the LED indication remains.
DISABLE/ ENABLE LED blinks.
The ZONE 1 yellow LED blinks if ZONE 1 is en-
abled and lights permanently if ZONE 1 is disabled.
The respective zone yellow LED blinks.
The yellow LED of the disabled zone lights up per-
manently.
At this step the zone is disabled.
DISABLE/ ENABLE LED blinks.
The ZONE 1 yellow LED blinks if ZONE 1 is en-
abled and lights permanently if ZONE 1 is disabled.
The yellow LED of the disabled zone lights up per-
manently.
At this step the zone is enabled.
Description
RESET" button and upon the initial start-up of
ENABLE/DISABLE" button to enable/disable
TEST/SCROLL" button to access "One
13
Advertisement
Table of Contents
