Table of Contents
Advertisement
Fan Jumper Settings
The BPN-SAS-836A backplane can use up to four fans. To utilize each fan, both
jumpers must be configured as instructed below.
Jumper
Closed: With fan (default)
JP61
Open: No fan
JP54
Closed: With fan (default)
JP62
Open: No fan
JP56
Closed: With fan (default)
JP63
Open: No fan
JP58
Closed: With fan (default)
JP64
Open: No fan
JP60
1-2 With fan (default)
JP97
2-3 No fan
1-2 With fan (default)
JP99
2-3 No fan
1-2 With fan (default)
JP100
2-3 No fan
1-2 With fan (default)
JP100
2-3 No fan
I
C and SGPIO Modes and Jumper Settings
2
This backplane can utilize I
used without making changes to your jumpers. The following information details
which jumpers must be configured to use SGPIO mode or restore your backplane
to I
C mode.
2
Jumper
JP84
1-2 (default)
Fan Jumper Settings
Jumper Settings
C or SGPIO. SGPIO is the default mode and can be
2
SGPIO/I
SGPIO Jumper Setting
Appendix C Backplane Specifications
Fan#1 enable/disable
Fan#1 connector
Fan#2 enable/disable
Fan#2 connector
Fan#3 enable/disable
Fan#3 connector
Fan#4 enable/disable
Fan#4 connector
Fan #1 selection for MG907X
Monitor
Fan #2 selection for MG907X
Monitor
Fan #3 selection for MG907X
Monitor
Fan #4 selection for MG907X
Monitor
C Setting
2
I
C Jumper Setting
2
2-3
C-7
Note
Advertisement
Table of Contents
