Table of Contents
Advertisement
SC836 Chassis Manual
SC417B Chassis Cabling for SAS3 I
Use the diagram below to connect the I
on the CB3 JBOD control board is cabled correctly according to the figure below.
Jumper
Setting
Pins 1-2: SAS3 setting (Default)
JP5
Pins 2-3: SAS2 and SC847D setting
When enabling SAS2/SAS3 functionality, use the connectors on the upper left of
the CB3 JBOD control board (See Page E-4) and set the JP5 jumper as shown in
the chart above.
When an SC847D chassis is being used, use the connectors along the bottom
edge of the JBOD control board (See Page E-4) and set the JP5 jumper as shown
in the chart above.
CBL-CDAT-0601
JP1
JP2
JP3
CBL-CDAT-0601
CSE-PTJBOD-CB3
Figure CB3-8. SAS3 I
Jumper Settings
BPN-SAS3-216EL1/EL2
Connected to the Primary
I
C Connector (SMB)
2
C Cabling in the SC417B Chassis
2
E-10
C
2
C cabling. Ensure that the JP5 jumper
2
BPN-SAS3-216EL1/EL2
Connected to the Primary
I
C Connector (SMB)
2
CBL-CDAT-0601
BPN-SAS3-216EL1/EL2
Connected to the Primary
I
C Connector (SMB)
2
Advertisement
Table of Contents
