Table of Contents
Advertisement
SC847B Chassis Cabling for SAS3 I
Use the diagram below to connect the I
the CB3 power board is cabled correctly according to the figure below.
Jumper
Setting
Pins 1-2: SAS3 setting (Default)
JP5
Pins 2-3: SAS2 and SC847D setting
When enabling SAS2/SAS3 functionality, use the connectors on the upper left of
the CB3 power board power board (See Page E-4) and set the JP5 jumper as
shown in the chart above.
When an SC847D chassis is being used, use the connectors along the bottom
edge fo the power board (See Page E-4) and set the JP5 jumper as shown in the
chart above.
JP1
JP3
CSE-PTJBOD-CB3
Figure CB3-7. SAS3 I
Jumper Settings
CBL-CDAT-0601
CBL-CDAT-0601
C Cabling in the SC847B Chassis
2
Appendix E: CB3 JBOD Control Board
C
2
C cabling. Ensure that the JP5 jumper on
2
Front Backplane BPN-SAS3-
846EL1/EL2 Connected to the
Primary I
2
Rear Backplane
BPN-SAS3-826EL1/EL2
Connected to the Primary I
Connector (I2C4)
E-9
C Connector (I2C0)
C
2
Advertisement
Table of Contents
