Table of Contents
Advertisement
D-3 Installing Hard Drives in the Rear Drive Carriers
The two 2.5" hard drives are hot-swappable and may be removed or replace without
powering down the server. Note that only enterprise level hard drives are recom-
mended for use in Supermicro chassis.
Installing the Hard Drives in the Carrier
1. Remove the screws securing the dummy drive to the hard drive carrier and
remove the dummy drive from the carrier.
2. Insert a hard drive into the carrier with the PCB side facing down and the
connector end toward the rear of the carrier.
3. Allign the mounting holes in the drive with those in the carrier. Note that there
are holes in the carrier marked "SAS" or "SATA" to aid in correct installation.
4. Secure the drive to the carrier with four screws. Use the four M3 flat-head
screws included in the HDD bag of your accessory box. Note that the screws
used to secure the dummy drive to the tray cannot be reused to secure the
hard drive.
Figure D-8. Removing the Dummy Drive from the Hard Drive Carrier
Appendix D: SC836B Added Features
D-5
Advertisement
Table of Contents
