Chapter 55 VRRP
Figure 411 VRRP Example 1: VRRP Parameter Settings on Switch B
EXAMPLE
After configuring and saving the VRRP configuration, the VRRP Status screens for both switches are
shown next.
Figure 412 VRRP Example 1: VRRP Status on Switch A
EXAMPLE
Figure 413 VRRP Example 1: VRRP Status on Switch B
EXAMPLE
55.4.2 Two Subnets Example
The following figure depicts an example in which two switches share the network traffic. Hosts in the two
network groups use different default gateways. Each switch is configured to backup a virtual router
using VRRP.
You wish to configure switch A as the master router for virtual router VR1 and as a backup for virtual
router VR2. On the other hand, switch B is the master for VR2 and a backup for VR1.
XGS4600 Series User's Guide
507