ZyXEL Communications XGS4600 Series User Manual page 183

Table 67 Advanced Application > Bandwidth Control (continued)
LABEL DESCRIPTION
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Ingress Rate
Active Select this check box to activate commit rate limits on this port.
Commit Specify the guaranteed bandwidth allowed in kilobits per second (Kbps) for the incoming traffic
Rate
flow on a port. The commit rate should be less than the peak rate. The sum of commit rates cannot
be greater than or equal to the uplink bandwidth.
Active Select this check box to activate peak rate limits on this port.
Peak Rate Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming traffic flow
on a port.
Active Select this check box to activate egress rate limits on this port.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields.
Chapter 14 Bandwidth Control
XGS4600 Series User's Guide
183