ZyXEL Communications XGS4600 Series User Manual page 272

Figure 211 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN > Port Role
Setting (Stacking Mode)
The following table describes the fields in the above screen.
Table 108 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN > Port Role
Setting
LABEL
MLD Snooping-proxy
VLAN ID
SLOT
Port
*
Port Role
Chapter 25 Multicast
DESCRIPTION
Select the VLAN ID for which you want to configure a port's MLD snooping-proxy settings.
This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
This field displays the port number. In stacking mode, the first number represents the slot
ID and the second is the port number. Please note that the default stacking ports (the
last two ports of your Switch) cannot be configured. They are reserved for stacking only.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
A port on the Switch can be either a Downstream port or Upstream port in MLD. A
downstream port connects to MLD hosts and acts as a multicast router to send MLD
queries and listen to the MLD host's Report and Done messages. An upstream port
connects to a multicast router and works as a host to send Report or Done messages
when receiving queries from a multicast router.
Otherwise, select None if the port is not joining a multicast group or does not belong to
this VLAN.
XGS4600 Series User's Guide
272