Dhcp Snooping Vlan Configure - ZyXEL Communications XGS4600 Series User Manual

28.3.2 DHCP Snooping VLAN Configure

Use this screen to enable DHCP snooping on each VLAN and to specify whether or not the Switch adds
DHCP relay agent option 82 information to DHCP requests that the Switch relays to a DHCP server for
each VLAN.
To open this screen, click Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP
Snooping > Configure > VLAN.
Figure 235 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP Snooping >
Configure > VLAN
The following table describes the labels in this screen.
Table 128 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP Snooping >
Configure > VLAN
LABEL
VLAN Search by VID Enter the VLAN ID you want to manage. Use a comma (,) to separate individual VLANs or a
Search
VID
Enabled
Option 82 Profile
Apply
Cancel
Change Pages
Chapter 28 DHCP Snooping
DESCRIPTION
dash (–) to indicates a range of VLANs. For example, "3,4" or "3–9".
Click this to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above. If you configure
the * VLAN, the settings are applied to all VLANs.
Select Yes to enable DHCP snooping on the VLAN. You still have to enable DHCP snooping
on the Switch and specify trusted ports.
Note: The Switch will drop all DHCP requests if you enable DHCP snooping and
there are no trusted ports.
Select a pre-defined DHCP option 82 profile that the Switch applies to all ports in the
specified VLANs. The Switch adds the information (such as slot number, port number, VLAN ID
and/or system name) specified in the profile to DHCP requests that it broadcasts to the DHCP
VLAN, if specified, or VLAN. You can specify the DHCP VLAN in the DHCP Snooping Configure
screen.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
Click Previous or Next to show the previous/next screen if all status information cannot be
seen in one screen.
XGS4600 Series User's Guide
308