Dhcp Snooping Port Configure - ZyXEL Communications XGS4600 Series User Manual

Table 126 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP Snooping >
Configure (continued)
LABEL
Apply
Cancel

28.3.1 DHCP Snooping Port Configure

Use this screen to specify whether ports are trusted or untrusted ports for DHCP snooping.
Note: The Switch will drop all DHCP requests if you enable DHCP snooping and there are no
trusted ports.
You can also specify the maximum number for DHCP packets that each port (trusted or untrusted) can
receive each second.
To open this screen, click Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP
Snooping > Configure > Port.
Figure 233 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP Snooping >
Configure > Port (Standalone Mode)
Chapter 28 DHCP Snooping
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
XGS4600 Series User's Guide
306