ZyXEL Communications XGS4600 Series User Manual page 215

Layer 3 managed stackable gigabit ethernet switch
Hide thumbs Also See for XGS4600 Series:
Table of Contents

Advertisement

Figure 172 Advanced Application > Port Authentication > MAC Authentication (Stacking Mode)
The following table describes the labels in this screen.
Table 80 Advanced Application > Port Authentication > MAC Authentication
LABEL
DESCRIPTION
Active
Select this check box to permit MAC authentication on the Switch.
Note: You must first enable MAC authentication on the Switch before configuring it
Name Prefix
Type the prefix that is appended to all MAC addresses sent to the RADIUS server for
authentication. You can enter up to 32 printable ASCII characters.
If you leave this field blank, then only the MAC address of the client is forwarded to the RADIUS
server.
Delimiter
Select the delimiter the RADIUS server uses to separate the pairs in MAC addresses used as the
account user name (and password). You can select Dash (–), Colon (:), or None to use no
delimiters at all in the MAC address.
Case
Select the case (Upper or Lower) the RADIUS server requires for letters in MAC addresses used
as the account user name (and password).
Password Type
Select Static to have the Switch send the password you specify below or MAC-Address to use
the client MAC address as the password.
Password
Type the password the Switch sends along with the MAC address of a client for authentication
with the RADIUS server. You can enter up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ],
[ " ] or [ , ].
Chapter 18 Port Authentication
on each port.
XGS4600 Series User's Guide
215

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xgs4600-32Xgs4600-32fXgs4600-52f

Table of Contents