Arp Inspection Port Configure - ZyXEL Communications XGS4600 Series User Manual

Table 133 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure (continued)
LABEL
Apply
Cancel

29.2.1 ARP Inspection Port Configure

Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can also
specify the maximum rate at which the Switch receives ARP packets on each untrusted port. To open
this screen, click Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port.
Figure 242 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port (Standalone Mode)
Figure 243 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port (Stacking Mode)
Chapter 29 ARP Inspection
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
XGS4600 Series User's Guide
316