Interface Setup - ZyXEL Communications XGS4600 Series User Manual

Table 22 Basic Setting > Port Setup (continued)
LABEL
BPDU Control
Media Type
Apply
Cancel

8.8 Interface Setup

An IPv6 address is configured on a per-interface basis. The interface can be a physical interface (for
example, an Ethernet port) or a virtual interface (for example, a VLAN). The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Use this screen to set IPv4 loopback interfaces for routing protocols or IPv6 interfaces on which you can
configure an IPv6 address to access and manage the Switch.
Click Basic Setting > Interface Setup in the navigation panel to display the configuration screen.
Figure 75 Basic Setting > Interface Setup
Chapter 8 Basic Setting
DESCRIPTION
Configure the way to treat BPDUs received on this port. You must activate bridging control
protocol transparency in the Switch Setup screen first.
Select Peer to process any BPDU (Bridge Protocol Data Units) received on this port.
Select Tunnel to forward BPDUs received on this port.
Select Discard to drop any BPDU received on this port.
Select Network to process a BPDU with no VLAN tag and forward a tagged BPDU.
You can insert either an SFP+ transceiver or an SFP+ Direct Attach Copper (DAC) cable into the
10 Gigabit interface of the Switch.
Select the media type (sfp_plus or dac10g) of the SFP+ module that is attached to the 10
Gigabit interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS4600 Series User's Guide
99