Ipv6 Static Binding Setup - ZyXEL Communications XGS4600 Series User Manual

Table 136 Advanced Application > IP Source Guard > IPv6 Source Binding Status (continued)
LABEL
MAC Address
VLAN
Port
Lease
Type

29.5 IPv6 Static Binding Setup

Use this screen to manually create an IPv6 source guard binding table entry and manage IPv6 static
bindings. Static bindings are uniquely identified by the source IPv6 address / prefix. Each source IPv6
address / prefix can only be in one static binding. If you try to create a static binding with the same
source IPv6 address / prefix as an existing static binding, the new static binding replaces the original
one. To open this screen, click Advanced Application > IP Source Guard > IPv6 Static Binding Setup.
Figure 246
Chapter 29 ARP Inspection
DESCRIPTION
This field displays the source MAC address in the binding. If the entry is blank, this field will not
be checked in the binding.
This field displays the source VLAN ID in the binding. If the entry is blank, this field will not be
checked in the binding.
This field displays the port number in the binding. If this field is blank, the binding applies to all
ports.
This field displays how many days, hours, minutes, and seconds the binding is valid; for
example, 2d3h4m5s means the binding is still valid for 2 days, 3 hours, 4 minutes, and 5
seconds. This field displays infinity if the binding is always valid (for example, a static binding).
This field displays how the Switch learned the binding.
S: This static binding was learned from information provided manually by an administrator.
DH: This dhcp-snooping binding was learned by snooping DHCP packets.
Advanced Application > IP Source Guard > IPv6 Static Binding Setup (Standalone Mode)
XGS4600 Series User's Guide
320