Figure 462 Management > Diagnostic (Stacking Mode)
The following table describes the labels in this screen.
Table 271 Management > Diagnostic
LABEL
DESCRIPTION
Ping Test
IPv4
Select this option if you want to ping an IPv4 address, and select which traffic flow (in-band
or out-of-band) the Switch is to send ping frames.
If you select in-band, the Switch sends the frames to all ports except the management port
(labeled MGMT).
If you select out-of-band, the Switch sends the frames to the management port (labeled
MGMT).
Otherwise, select – to send ping requests to all VLANs on the Switch.
IPv6
Select this option if you want to ping an IPv6 address. You can also select vlan and specify
the ID number of the VLAN to which the Switch is to send ping requests. Otherwise, select – to
send ping requests to all VLANs on the Switch.
IP Address/Host
Type the IP address or host name of a device that you want to ping in order to test a
Name
connection.
Click Ping to have the Switch ping the IP address.
Count
Enter the number of ICMP Echo Request (ping) messages the Switch continuously sends.
Trace Route Test
Chapter 60 Diagnostic
XGS4600 Series User's Guide
561