ZyXEL Communications XGS4600 Series User Manual page 186

Table 68 Advanced Application > Broadcast Storm Control (continued)
LABEL DESCRIPTION
Port This field displays the port number. In stacking mode, the first number represents the slot ID and
the second is the port number. Please note that the default stacking ports (the last two ports of
your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Broadcast (pkt/s) Select this option to enable and specify how many broadcast packets the Switch accepts per
second on the port.
The Switch will generate a trap and/or log when the actual rate is higher than the specified
threshold.
Multicast (pkt/s) Select this option to enable and specify how many multicast packets the Switch accepts per
second on the port.
The Switch will generate a trap and/or log when the actual rate is higher than the specified
threshold.
DLF (pkt/s) Select this option and specify how many destination lookup failure (DLF) packets the port
receives per second.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields.
Chapter 15 Broadcast Storm Control
XGS4600 Series User's Guide
186