Using This Manual - Typographical Conventions - Advanced Poly-Packaging Advanced Poly-Bagger T-1000-S18H Operation Manual

E-Stop: This option can be used to stop the cycle operation of the T-1000-S14 and possibly other
auxiliary infeed or outfeed equipment purchased with the T-1000-S14.
FS-10 Flat Seal Assembly: Helps decrease/eliminate wrinkles in the seal by pulling the sides of the bag.
Increases bag integrity.
FS-30 Heavy Duty Flat Seal Assembly (Drop Frame): Uses two movements to further assist in
flattening the film to decrease wrinkles or folds in the seal.
LAN Connection: Provides for Ethernet communication.
LC-10 Light Safety Curtain: If funnels are removed, APPI highly recommends the addition of this
option to prevent injuries. This option, when activated, prevents outputs (voltage) to valves that cause the
seal bar to activate. Additionally, the stepper motor stops when blocked.
LS-10 Load / Support Shelf: Provides support for heavier packages when dropped into bag. Sizes: 10",
15" or 20" long.
MV-10 Seal Validation: Additional components provide a secondary means of detecting a failure or out
of range condition for components that affect seal quality.
NBO Next Bag Out Printer: An inline printer installed within the T-1000-S14 capable of printing the
next bag out in the bagging sequence. This feature prevents mislabeling of pharmaceuticals, prescriptions
or high cost items and allows part numbers or other printing information to be changed with every bag.
OFS-10 Output Fault Signal with SL-10 Stack Light: For automatic bagging operations with third
party or production equipment, this signal provides a fault when the bagger is inoperative (due to out of
bag conditions or other faults).
PB-20 Dual Palm Buttons: Decreases the possibility of injury to hands and fingers. The operator must
push two buttons simultaneously to actuate the seal bar.
Roll-a-Print 1400 or 2800 Single or Dual Thermal Inline Printer: Prints bar codes and graphics
directly to the surface of the front or both the front and back of the bag.
Ti-1000 Thermal Transfer Inline Printer: Prints bar codes, graphics, etc. by downloading pre-
formatted labels, generated via label software. (PC or Terminal and software required)
TS-10 Trim Seal Assembly: Trims excess film from the bag above the seal to enhance the appearance of
the package. Great for retail products.
TM
Twin-Seal : Seal the bag a second time, 3/8" from the first seal, for additional bag integrity.
10