Table of Contents
Advertisement
Operating instructions
4.2.2 Emergency stop function
4.2.3 Guaranteed final rinse
Washing with manual operation
Press button (4) for manual operation. The corresponding LED (3) lights up.
Button for manual operation
Washing without automatic stop. The machine starts straight away. Manual oper-
ation is a good idea when the items are heavily soiled. If you only feed in one bas-
ket, it stops and stays in the washing zone. The time in the zone is decided by the
operator. The basket is pushed out of the machine when a new basket is fed in.
Start the feed by pressing the button (5).
The machine has an emergency stop button (11). If the machine has been
stopped during operation using the emergency stop button, the button must be re-
set by turning it in the direction of the arrows. Then press the button (5) to restart
the feed.
The temperature of the final rinse water is always correct and the right amount of
rinse water is always used.
If the rinse temperature is too low, an alarm is triggered on the control panel. The
machine continues washing until the right temperature is reached. However, the
alarm can be reset in the meantime by pressing button (8) on the panel. The wash
program continues, but the machine will then rinse at a lower temperature. How-
ever, an alarm is displayed.
If the flow during the final rinse is too low, an alarm is displayed on the control pan-
el. The alarm can also be set up to stop the machine. The factory setting is for an
alarm only. If you need an alarm which stops the machine, the setting must be
changed by a service engineer in the machine's software.
WD-11
42
Rev. 5.0 (202206)
Advertisement
Table of Contents
