Limit Switch; Conveyors; Emergency Stop - Wexiodisk WD-215T touch Installation And User Manual

Installation instructions

3.6.3 Limit switch

3.6.4 Conveyors

3.6.5 Emergency stop

WD-215T & WD-275T
The Limit switch is installed on the lower terminal block, which is placed in front
of the chemical wash tank. When connecting, remove the existing clamp on the
connection points. See the machine's wiring diagram. N.B.! The machine's volt-
age is 24V.
Installation of in- and outfeed equipment (conveyors, curves) must be performed
in accordance with the wiring diagram's main circuit instructions. This applies to
machines equipped with a motor switch and contactors for this equipment.
Connection of supply voltage to the in- and outfeed equipment is performed in ac-
cordance with the wiring diagram's instructions. N.B.! The machine's voltage is
24V.
When fitting a motor switch and contactors retrospectively, use the components
on the wiring diagram and follow the connection instructions. This affects the
manufacturer's liability - see "SAFETY INSTRUCTIONS".
An additional emergency stop can be connected at the lower terminal block,
which is placed in front of the chemical wash tank. Replace the existing clamp on
the connection points when connecting a new emergency stop. See the ma-
chine's wiring diagram. N.B.! The machine's voltage is 24V.
touch
27
Rev. 00 (202310)