Table of Contents
Advertisement
Operating instructions
ALARM MESSAGE
(98) HARDWARE ERROR
POWER ON FUNCTION
DEFECT
CALL SERVICE
(1)
EMERGENCY STOP
ACTIVATED
(3)
NOMINAL VALUES
CORRUPTED IN MEMORY
CALL SERVICE
(99)
THE MACHINE TYPE
IS CHANGED. VERIFY
THE CHANGE.
(100)
NOMINAL VALUES
RESTORED FROM UI
(2)
INPUT FAILURE ON
DIGITAL INPUTS
CALL SERVICE
(4) COMMUNICATION
ERROR BETWEEN
CPU AND I/O 1
CALL SERVICE
(6) COMMUNICATION
ERROR BETWEEN
CPU AND EXTRA CARD
CALL SERVICE
(7) COMMUNICATION
ERROR BETWEEN
CPU AND DISPLAY CARD
CALL SERVICE
(14) WEAK SIGNAL
FROM PHOTOCELL
START WASH
CLEAN PHOTOCELL
(47) HACCP ALARM
PUMP FUNCTIONALITY
DEFECT
PRESS RESET
(48) HACCP ALARM
PUMP DEFECT
MACHINE LOCKED
CALL SERVICE
(64) HACCP ALARM
WRONG TEMPERAURE
IN TANK
PRESS RESET
(65) HACCP ALARM
WRONG TEMPERATURE
IN TANK. MACHINE
LOCKED. CALL SERVICE
WD-11
ACTION
Restart the machine. If the error recurs, contact an authorised service company.
Reset the emergency stop by turning the knob in the direction of the arrows.
Start feed.
Contact service personnel!
This alarm should not occur on normal operation. If it does, contact service per-
sonnel.
Reset the alarm. If the error recurs, contact an authorised service company.
Contact service personnel!
Restart the machine.
Restart the machine.
Restart the machine.
Clean the photocell. The alarm in the display will disappear after cleaning.
Reset the alarm. If the error recurs, contact an authorised service company.
Same as alarm 47 but the difference is that the wash stops when the alarm is
activated.
Reset the alarm. If the error recurs, contact an authorised service company.
Same as alarm 64 except that the wash stops when the alarm is activated and
that it is not possible to reset the alarm by pressing the reset button. Contact ser-
vice personnel!
50
Rev. 5.0 (202206)
Advertisement
Table of Contents
