Table of Contents
Advertisement
Operating instructions
4.1.4 Filing and heating the machine using TimerStart (optional)
Using the TimerStart function, the dishwasher can start filling and heating water
in the washing tank automatically at a set time. The dishwasher is then ready for
washing when the next wash cycle starts and you don't have to wait for the ma-
chine to fill the tanks and heat the tank water before washing can start, which
takes approx. 30 minutes.
For machines equipped with the TimerStart function, the machine must be in
stand-by mode in order to start automatically, i.e. the TO/FROM BUTTON (10) is
pressed and the following message is shown on the machine's display (1):
TIMERSTART
ACTIVATED
Timer
The switch (B) on the timer should be set to AUTO position.
If you want to bypass the TimerStart function and start manually, press the ma-
chine's TO/FROM button (10) once more when the message above is shown on
the display. The filling and heating of the machine can then start as normal, i.e.
by pressing buttons (2 or 4).
Once the wash and draining of the dishwasher has been completed, it must be
switched off and set with the TO/FROM button (10) for the machine to enter
stand-by mode. It is therefore not enough just to stop the wash cycle and/or to
empty the washing tanks to put the machine into this mode.
WD-11
SET
A
90-9-05-002-a
A=Buttons for setting and checking
B=Switch
C=Display
28
C
B
Rev. 5.0 (202206)
Advertisement
Table of Contents
