Table of Contents
Advertisement
Operating instructions
4.3.3 Operating problems
PROBLEM
No indication on the control pan-
el display when the control but-
ton is pressed.
The machine does not fill with
water.
The machine fills slowly.
The machine does not stop fill-
ing.
The machine does not start
washing.
Noise from the washing pump.
Check:
•
Has the appliance been used according to the instructions?
•
Are all the removable parts in their correct place?
•
Is the main switch in the ON position?
•
Are there any error messages on the display?
•
Are the fuses in the electrical cabinet still intact? Ask service personnel to
check the fuses.
Troubleshooting
The following errors can be dealt with by the operator. If the problem persists,
contact authorised service personnel.
CAUSE
Power switch off.
The incoming water stopcock is
closed.
The door/hood is open.
The final rinse pipe nozzles are
blocked.
The final rinse pipe nozzles are
blocked.
Level pipe or drain seal not in place.
The level pipe or one of drain seals'
rubber sleeves are not sealing
against the bottom plate.
The door/hood is open.
Dishware is blocking the magnet in
the door.
Outward feed conveyor limit switch
has been activated.
Low water level. Foam in the tank.
WD-11
ACTION
Switch on the power switch.
Open the tap.
Close the door/hood.
Clean the wash nozzles.
Clean the wash nozzles.
Fit the level pipe or drain seal.
Check that the level pipe and drain
seals are closed. Replace the rubber
sleeves, if they are damaged.
Close the door/hood.
Remove the dishes in question.
Remove the basket from the limit
switch.
Check the level. Change the water.
47
Rev. 5.0 (202206)
Advertisement
Table of Contents
