Table of Contents
Advertisement
TRIMMER INSTALLATION
24. Send one A3/11 x 17" job to the Booklet maker.
25. Check for the correct feeding of the sheets.
NOTE: The sheets should enter in the middle of the infeeder. If not, adjust the
Booklet maker according to section (
26. Remove the interlock cheater and close the top cover.
If a Cover Feeder CF 5030 is installed, proceed with step 27 and onwards. If not,
the installation check is finished.
27. A. Prepare a 15mm high stack of A4/8.5 x 11" covers.
B. Make sure that the ink has dried out well, to avoid smearing.
C. Make sure that the covers are well fanned to avoid misfeeds or double-
feeds.
D. Align the covers well to achieve a reliable collating operation and good fin-
ishing result.
E. Press down the green marks on Paper bin and load the covers.
F. Move the adjustable side guides up against the covers, until there is no clear-
ance.
G. Set up the Cover Feeder to Cover ON, the fan will start and the Cover
Feeder will prefeed the first cover to be ready for the set from the copier.
28. Set up the Booklet maker to A4/8.5 x 11" paper size.
29. Send one A4/8.5 x 11" job to the Booklet maker system.
30. Check that the covers are correctly fed into the Booklet maker.
1.3.3 on page 1-14).
Use an interlock cheater and run the machine
with the top cover open.
Verify that the sheet enters the Booklet Maker
centered between the side guides.
1-45
November 2012
Advertisement
Table of Contents
