Table of Contents
Advertisement
BOOKLET MAKER INSTALLATION
Rail Unit
[A]
1.
If installing a Rail Unit [A], install it according to picture.
Select correct rail hole[C].
NOTE: If the Rail unit is installed at a later time the height adjustment of the
Booklet maker has to be redone.
2.
Hook up the Exit arm catcher to it's upper position.
CAUTION
Before docking, make sure the Jogger Fence [B] is in the upper position.
If not, with printer powered on - open and close finisher door.
3. Push the Booklet maker onto the rail but leave it undocked with the finisher at
this time.
[B]
1-12
November 2012
Select this hole if CT5010 /CT5030
is installed
Select this hole if CT5010 /CT5030
is NOT installed
[C]
Advertisement
Table of Contents
