November 2012
1.3.5 CHECK THE INSTALLATION
1.
If installing a Cover Feeder CF5030 or Trimmer TR5030, continue to that sec-
tion (
1.4 or 1.5 ) otherwise continue with step 2.
2.
Turn on the power for the Booklet maker.
NOTE: Make sure that the finisher connector is connected to the copier.
3.
Pull out both staple cartridges [A] and close the top cover.
4.
Undock the BK5030 from the copier.
5.
Press the [Tools] button and then the [Service] button.
6.
Key in password 107 and press the [OK] button.
7.
Select BK5030 and press the [Enter] button.
8.
Go to Diagnostics and press the [OK] button then press the [Start] button.
9.
If you should receive a fault code after performing a Detailed self diagnostic, a
service manual and trained technician is required to solve the problem.
10. IMPORTANT:
ALWAYS POWER OFF THE SYSTEM WHEN EXITING THE DIAGNOSTIC
MODE.
11. Reinstall the two Stapler cartridges and close the top cover.
12. Dock the BK5030 to the copier.
13. Turn on the power to the Booklet maker and the copier.
NOTE: Make sure that the Booklet maker is powered ON before the copier.
BOOKLET MAKER INSTALLATION
1-19
[A]