Table of Contents
Advertisement
BOOK FOLDER INSTALLATION
1.6.6 CONNECTORS
Trimmer without Book Folder installed
Trimmer with Book Folder installed
1.
Move the Belt stacker cable [A] to the Book Folder (
NOTE: Do not connect the Belt stacker cable [A] to the Trimmer.
2.
Move the Terminator plug [B] from the Trimmer to the Book Folder (
3.
Install the communication cable [C] between the Trimmer and the Book Folder
(
x 1).
4.
Connect the power cord from the BK5030 to the BF5030
5.
Mount the cable protector [D] positioned as shown with two screws in the
holes [E] and route the cables inside the cable protector (
6.
Install the cable holder [F] to the hole [G] on the rear side of the Book Folder
base.
[B]
[C]
[D]
1-59
November 2012
[A]
Book Folder
x 1).
x 1).
x 2).
[E]
Advertisement
Table of Contents
