Connectors - Plockmatic BK5030 Installation Manual

TRIMMER INSTALLATION

1.5.5 CONNECTORS

1. Connect the Belt stacker cable [A] to the Trimmer (
NOTE: Unless a Book folder BF5030 also will be installed. If so, the Belt
stacker cable will be connected to the Book folder instead.
2. Remove the Trimmer Terminator plug from the Booklet maker [B] (
3. Connect the Trimmer Terminator plug on the Trimmer [C] (
4. Remove the Interlock jumper [D] from the Booklet maker (
5. Connect the Interlock jumper to the Booklet maker frame [E] (
next spread). This jumper will be stored in this area, it will be needed later on
to allow the Booklet maker to function while the Trimmer is serviced.
6. Connect the communication cable to the Trimmer [F] (
NOTE: The communication cable you received with the Trimmer.
7. Connect, the other end of the communication cable, to the Booklet maker [G]
( x1).
8. Connect the powercord to the Trimmer [H] (
9. Connect, the other end of the powercord, to the Booklet maker [ I ] (
10. Mount the cable protector [J] positioned as shown with two screws in the holes
[K] and route the cables inside the cable protector (
11. Install the cable holder [L] to the hole [M] on the rear side of the Trimmer base.
12. Route cables through the cable holders on the rear of the Booklet Maker and
Trimmer.
Continued on next page....
Booklet Maker without Trimmer installed
1-41
November 2012
x1).
x1).
x1).
x1) (see
x1).
x1).
x 2).
x1).
x1).
[B]
[D]