Table of Contents
Advertisement
BOOKLET MAKER INSTALLATION
1.3.4 CONNECTORS
1. Connect the Communication cable [A] from the finisher (
let Maker.
2.
Connect the Belt Stacker cable [B] (
NOTE: Unless Trimmer TR5030 and/or Book Folder BF5030 will be installed.
If so, Belt Stacker cable will be connected to the last module in the system.
3.
Install the Terminator plug [C].
NOTE: The Terminators and Interlock jumpers are included in the installation
kit.
4.
Install the Terminator plug [D] and the Interlock jumper [E] .
NOTE: Unless Trimmer TR5030 will be installed. If so, communication cable
and power cord between BK5030 and TR5030 will be connected.
5.
Connect the Power cord [F] to the Booklet Maker (
6.
Mount the cable protector [G] positioned as shown with two screws in the
holes [H] and route the cables inside the cable protector (
7.
Install the cable holders [I] to the holes on the rear side of the Booklet Maker
base and route the cables through them.
[G]
[H]
[A]
[B]
[C]
1-18
x1).
x1).
[E]
[D]
Only Booklet Maker installed
November 2012
x1), to the Book-
x 2).
[F]
[I]
Advertisement
Table of Contents
