Table of Contents
Advertisement
ADJUSTMENT
November 2012
1.7.5 ADJUSTMENT
1. Adjust Infeed and Outfeed height before docking CT5030 to Printer and Booklet Maker. Turn
casters Rear (x2) and Front (x2) [A].
Adjust casters using the Multi tool.
Turn Clockwise to raise CT5030 and CCW to lower.Ensure that gaps in-between covers are paral-
lel after docking. (Docking Latch(es)) (
CT5030 Servicemanual REP 3.4).
Note: When adjusting the casters on the CT 5030 do not turn each caster more than 2 full revolu-
tions before adjusting the other casters.
[A]
2. Check that there is no interference between the CT 5030 infeed baffle and the finisher outfeed.
3. Check that the alignment between the CT5030 Exit Baffle and the Booklet Maker Infeed Baffle
is adequate. This can be done with the help of a ruler or a piece of paper. Raise or lower rear and
/ or front set of casters as needed. Raise / lower casters equally.
4. Perform Front / Rear adjustment of Infeed docking bracket.
The center of sheets entering from the printer should hit 232 ± 3 (9.1"±0.12") mm from inner side
of Out Board Frame. (
CT5030 Servicemanual REP 3.4.2 Docking bracket Infeed).
5. Perform Front / Rear adjustment of Outfeed Docking bracket.
The sheets should hit symmetrical in-between side jogger rails in the Booklet Makers compiler
section. (
CT5030 Servicemanual REP 3.4.3 Docking bracket Outfeed. )
6. Make sure that the CT 5030 Front Covers are aligned and parallell with the Finisher.
1-94
Advertisement
Table of Contents
