Plockmatic BK5030 Installation Manual page 37

COVER FEEDER INSTALLATION
14. Open the Booklet maker top cover and install an interlock cheater to be able
to run the Booklet maker with the top cover open.
WARNING:
• To avoid hazardous situations, please read and follow the safety information
in the beginning of this manual.
15. Set up the Booklet maker to Auto paper size and Staple On.
16. Check that the Booklet maker is set to "Staple On".
17. Send one A4/8.5 x 11" job to the Booklet maker.
18. Check for the correct feeding of the sheets.
NOTE: The sheets should enter in the middle of the infeeder. If not, adjust the
Booklet maker according to section (
19. Send one A3/11 x 17" job to the Booklet maker.
20. Check for the correct feeding of the sheets.
NOTE: The sheets should enter in the middle of the infeeder. If not, adjust the
Booklet maker according to section (
21. Remove the interlock cheater and close the top cover.
22. A. Prepare a 15mm high stack of A4/8.5 x 11" covers.
B. Make sure that the ink has dried out well, to avoid smearing.
C. Make sure that the covers are well fanned to avoid misfeeds or double-
feeds.
D. Align the covers well to achieve a reliable collating operation and good fin-
ishing result.
1.3.3 on page 1-14).
1.3.3 on page 1-14).
Use an interlock cheater and run the machine
with the top cover open.
Verify that the sheet enters the Booklet Maker
centered between the side guides.
1-30
November 2012