Table of Contents
Advertisement
November 2012
12. Pull out both staple cartridges [A] and close the top cover.
13. Undock the BK5030 from the copier.
14. Go to Diagnostics and press the [OK] button then press the [Start] button.
15. If you should receive a fault code after performing a Detailed self diagnostic, a
service manual and trained technician is required to solve the problem.
16. IMPORTANT:
ALWAYS POWER OFF THE SYSTEM WHEN EXITING THE DIAGNOSTIC
MODE.
17. Reinstall the two Stapler cartridges and close the top cover.
18. Dock the BK5030 to the copier.
19. Turn on the power to the Booklet maker and the copier.
NOTE: Make sure that the Booklet maker is powered ON before the copier.
20. Open the Booklet maker top cover and install an interlock cheater to be able
to run the Booklet maker with the top cover open.
WARNING:
• To avoid hazardous situations, please read and follow the safety information
in the beginning of this manual.
21. Set up the Booklet maker to Auto paper size, Staple On, Cover Off and Trim
On.
22. Send one A4/8.5 x 11" job to the Booklet maker.
23. Check for the correct feeding of the sheets.
NOTE: The sheets should enter in the middle of the infeeder. If not, adjust the
Booklet maker according to section (
TRIMMER INSTALLATION
1.3.3 on page 1-14).
1-44
[A]
Advertisement
Table of Contents
