LM180E
Handling Instructions
6.
Install the belts for left and right mower units
and for rear mower unit.
Adjustment of Cutting Height
Important
The front wheel is provided to prevent the reel
cutter (cutting cylinder) from damaging a
convex portion of the lawn surface.
Adjust the height so that the front wheel will
not be grounded but raised by 10 - 20 mm
(0.39 - 0.79 in) off the ground.
The cutting height is adjusted by moving the
roller up or down.
Refer to the cutting height scale plate to decide
the height.
1.
To increase cutting height:
Loosen nut A, lower the roller, then tighten
nut B.
2.
To decrease cutting height:
Loosen nut B, raise the roller, then tighten
nut A.
6
4
Adjustment of Cutting Height_001
1
2
3
4
5
6
Page 4-12
3
5
3kws2a-002
Nut A
Nut B
Roller
Front wheel
Cutting height scale plate
Reel cutter (cutting cylinder)
1
2
Adjustment before Work