Table of Contents
Advertisement
Procedure to Start/Stop Engine
Start/Stop of Engine
Procedure to Start Engine
Caution
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.
1.
Sit on the seat.
2.
Make sure that the parking brake is applied.
3.
Make sure that the traveling clutch lever is
set to the "OFF" position.
4.
Make sure that the reel rotation lever is set
to the "Stop" position.
5.
Make sure that the change lever is set to
the neutral position.
6.
Set the fuel cock to the "Open" position.
The fuel cock is located under the fuel tank.
7.
Shift the throttle lever from the "Low speed"
position halfway to the "High speed"
position.
8.
Pull the choke knob.
Pull the knob half way for restarting, as
necessary.
9.
Set the engine switch to the "ON" position.
10.
Pull the starter grip swiftly, and the engine
will start.
Important
Return the starter grip slowly to its original
position after the engine starts.
Do not let go of the pulled starter grip since it
may cause damage to the machine.
11.
Make sure that the engine has started, and
then slowly return the choke knob to its
original position.
12.
Shift the throttle lever to the "Low speed"
position, and then warm up the engine for 1
to 2 minutes.
13.
Gradually move the throttle lever to the
"High speed" position.
Procedure to Start/Stop Engine
Handling Instructions
Procedure to Stop Engine
1.
Set the reel rotation lever to the "Stop"
position.
2.
Shift the throttle lever to the "Low speed"
position , and continue idling for 1 to 2
minutes.
3.
Shift the traveling clutch lever to the "OFF"
position.
4.
Depress the brake pedal.
5.
Apply the parking brake.
6.
Shift the change lever to the neutral
position.
7.
Set the engine switch to the "OFF" position.
8.
Make sure that the engine has stopped.
9.
Set the fuel cock to the "Close" position.
The fuel cock is located under the fuel tank.
10.
Leave the driver's seat.
Safety Mechanisms
This machine has the safety device for
starting / stopping engine.
1.
As for starting the engine, the safety device
prevents the engine from starting unless it
meets each of the following three
conditions.
An operator is sitting on the seat.
･
The parking brake lever is pulled.
･
The traveling clutch lever is in the "OFF"
･
position.
2.
In the case that the operator leaves the
seat with the engine running, the safety
device makes the engine stop unless it
meets each of the following two conditions.
The parking brake lever is pulled.
･
The traveling clutch lever is in the "OFF"
･
position.
LM180E
Page 4-13
Advertisement
Chapters
Table of Contents
