Change Of Engine Oil; Change Of Transmission Oil - Baroness LM180E Owner's Operating Manual

LM180E
Maintenance

Change of Engine Oil

Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When changing the engine oil, be sure to
drain it into a container and discard it in
accordance with local laws and regulations.
Important
Be sure to use engine oil that is classified as
API Service Grade SE or higher, with an SAE
viscosity that is appropriate for the operating
environment (ambient temperature).
Important
Securely tighten the oil level gauge.
Change the engine oil more frequently if it is
contaminated and especially if you use the
machine in dusty areas or operate the engine
at high loads or in high temperatures.
1. Move the machine onto a level surface, and
then stop the engine.
2. Install the drain gutter (accessory).
3. Remove the drain plug while the engine oil is
warm, and then drain the oil into a container.
2
3
Change of Engine Oil_001
1
2
3
4. Install the drain plug on the engine.
5. Remove the oil level gauge.
Page 5-24
gui678-028
Oil level gauge (oil filling port)
Drain plug
Drain gutter
6. Supply new engine oil through the oil filling
port.
The engine oil quantity is 1.0 dm
7. Position the machine so that the engine is
level, and then check the engine oil level
without tightening the oil level gauge in the
oil filling port.
8. After checking the oil level with the oil level
gauge, add more engine oil if it is insufficient.
9. Securely tighten the oil level gauge.
10. It will take a while for the supplied engine oil
to descend into the oil pan.
Check the oil level again 10 to 20 minutes
after replenishment.
11. Check underneath the machine for oil
leakage.

Change of Transmission Oil

Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When you change the transmission oil, be
sure to drain it into a bowl and discard it in
accordance with regional laws and
regulations.
Important
Be sure to pour automobile gear oil that is
classified as SAE Viscosity Grade #90 into the
1
transmission.
Change the entire transmission oil according to
the maintenance schedule.
1. Move the machine onto a level surface and
stop the engine.
2. Remove the drain plug while the
transmission oil is warm, and then drain the
oil into a bowl.
3. Attach the drain plug to the transmission.
4. Remove the oil filling port cap and oil level
plug.
5. Pour new transmission oil through the oil
filling port.
The transmission oil quantity is 2.0 dm
liters).
6. Make sure that the transmission oil level is
filled up to the tip of the oil level opening.
3
(1.0 L).
3
(2.0
Maintenance Work