Replacement Of Bed Knife (Bottom Blade); Removing/Installing Tires - Baroness LM180E Owner's Operating Manual

LM180E
Maintenance

Replacement of Bed Knife (Bottom Blade)

Caution
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
Caution
Wear gloves when touching edged tools to
avoid cutting your hands.
The criteria for replacing the bed knife (bottom
blade) are described below.
1. When the reel cutter (cutting cylinder) is
ground
2. When the reel cutter (cutting cylinder) is
replaced
3. When the bed knife (bottom blade) is worn
High-speed-steel-tipped blade
Replace the bed knife (bottom blade) before it
no longer has a tip.
3
A
Replacement of Bed Knife (Bottom Blade)_001
1
2
3
A
Page 5-16
1
2
d5gd5v-001
Bed knife (bottom blade)
Mounting hole
Tip
Front face

Removing/Installing Tires

Front Tires
Follow the steps below to remove the front
tires:
1. Loosen the bolts.
2. Place the tire jack beneath the jack-up point
of the front axle area securely, then raise it
until the tire lifts off the ground.
"Jack-up Points" (Page 5-6)
3. Remove the bolts.
4. Remove the tire from the wheel mounting
shaft.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the front tires, reverse the
removing procedure.
Rear Tires
Follow the steps below to remove the rear
tires:
1. Loosen the bolts.
lm2ieh-001
Front Tires_001
upekw4-001
Rear Tires_001
Maintenance Work