Operation - Baroness LM180E Owner's Operating Manual

[4] If fuel is spilled, do not attempt to start the
engine but move the machine away from
the area of spillage and avoid creating any
source of ignition until petrol vapours have
dissipated;
[5] Replace all fuel tanks and container caps
securely.
6. Check that operator's presence controls,
safety switches and shields are attached and
functioning properly.
Do not operate unless they are functioning
properly.
7. If the brake operation is faulty, be sure to
adjust or repair them before operating the
machine.
8. Replace faulty mufflers.
9. On multi-cylinder/multi-reel machines, take
care as rotating one cylinder/reel can cause
other cylinders/reels to rotate.

Operation

1. Do not operate the machine under the
influence of alcohol or drugs.
2. Do not operate the engine in a confined
space where dangerous carbon monoxide
fumes can collect.
3. Be sure all drives and shift are in neutral and
parking brake is engaged before starting
engine.
Only start engine from the operator's
position.
Use seat belts if provided.
4. Do not change the engine governor settings
or overspeed the engine.
Operating the engine at excessive speed
may increase the hazard of personal injury.
5. Pay attention not to touch hot parts.
6. Never operate the machine with damaged
guards, shields, or without safety protective
devices in place.
Be sure all interlocks are attached, adjusted
properly, and functioning properly.
7. Keep hands and feet away from the rotating
parts.
8. Do not carry passengers.
9. Never operate while people, especially
children, or pets are nearby.
10. Only operate in good light, keeping away
from holes and hidden hazards.
11. Do not operate the machine when there is
the risk of lightning.
Safe Operating Practices
12. Do not stop or start suddenly.
13. Look behind and down before backing up to
be sure of a clear path.
14. Slow down and use caution when making
turns and crossing roads and sidewalks.
15. Use care when approaching blind corners,
shrubs, trees, or other objects that may
obscure vision.
16. Do not take your eyes off the road ahead.
Do not operate the machine with no hands.
17. Remember there is no such thing as a safe
slope.
Travel on grass slopes requires particular
care.
To guard against overturning, follow these
instructions.
[1] Do not stop or start suddenly when going
up or downhill.
[2] Engage clutch slowly, always keep
machine in gear, especially when traveling
downhill.
[3] Machine speeds should be kept low on
slopes and during turns.
[4] Stay alert for humps and hollows and
other hidden hazards.
18. Never use the machine on a slope with an
angle of gradient that is greater than that
specified or in a place where there is a
danger of the machine slipping.
19. Disengage drive to the cutting unit(s), when
other than operating.
20. Do the following before leaving the
operator's position.
[1] Stop on level ground.
[2] Disengage the all drives.
[3] Set the parking brake.
[4] Stop the engine.
21. Stop the engine in the following conditions.
[1] Before refuelling.
[2] Before making height or depth adjustment
unless adjustment can be made from the
operator's position.
[3] Before clearing blockages.
[4] Before checking, cleaning or working on
the machine.
[5] After striking a foreign object or if an
abnormal vibration occurs.
Inspect the machine for damage and
make repairs before restarting and
operating the equipment.
LM180E
Safety
Page 1-3