Table of Contents
Advertisement
LM180E
Handling Instructions
Belt
Inspection of Belt
Warning
The engine must be stopped when the belt is
inspected.
Warning
If you have removed the covers, etc., during
inspection, be sure to securely install them in
their original positions.
If covers, etc., remain removed, the operator
may come in contact with rotating parts or
belts, possibly resulting in injuries.
Important
A slacking or damaged belt may cause the
cutter rotation speed or operation speed to be
insufficient for operation.
1.
Press the middle of the belt with your finger
to check the belt tension.
2.
Make sure that there are no cracks,
damage or abnormal wear.
Wire
Inspection of Wire
1.
Make sure that the wire is not cracked or
damaged.
2.
If the wire is cracked or damaged, replace it
with a new one immediately.
Electrical Wiring
Inspection of Electrical Wiring
Important
Electrical short circuit will cause fire, electrical
leakage and malfunction of electrical
equipments.
Inspect electrical wiring for poor terminal
connections, damaged wiring or terminals,
loose connections, weather-related
deterioration and chemical-related
deterioration.
If necessary, repair before operating the
machine.
Page 4-4
Around The Engine
Inspection around The Engine
1.
Check the fuel system parts for loosened or
cracked joints and leakage. Replace the
parts if necessary.
2.
Blow the air to clean any grass or
flammables attached on or around the
muffler.
3.
Blow air to clean any grass or flammables
attached around the cooling fins or recoil
starter.
Engine Oil
Inspection of Engine Oil
Important
Securely tighten the oil level gauge.
1.
Stop the engine, wait 10 to 20 minutes for
the engine to cool down, and then check
the oil level.
2.
Position the machine so that the engine is
level, and then check the engine oil level
without tightening the oil level gauge in the
oil filling port.
2
Inspection of Engine Oil_001
1
2
bgmiun-031
Oil level gauge (oil filling port)
Drain plug
Inspections
1
Advertisement
Chapters
Table of Contents
