Adjustment Of Cutting Height; Cutting Height And Blade Thickness Of Bed Knife (Bottom Blade) - Baroness LM315GC Owner's Operating Manual

If the reel cutter (cutting cylinder) is too
･
tight to turn:
Tighten (rotate clockwise) the cutter
adjustment nut to reduce the contact
pressure between the reel cutter (cutting
cylinder) and the bed knife (bottom blade).
If the sharpness is not improved by the
･
adjustment:
Perform back lapping.
Adjustment of Blade Engagement_002
1 Cutter adjustment nut
2 Spring
3 Pipe with cutter adjusting screw
Adjustment before Work

Adjustment of Cutting Height

Important
This applies the set cutting height that differs
from the actual cutting height.
Adjust the cutting height to fit your cutting work.
Adjustment of Rear Roller
1
2
3
2f8equ-006
Handling Instructions
LM315GC (for greensmowing)
You can adjust the rear roller by six stages.
1. Attach the rear roller in a position that
suits your work requirements within the
cutting height range.
Note:
The figure below shows the position of
the rear roller bracket with a new reel
cutter when using a 2.0 mm bed knife.
The lowest cutting height differs with
thickness of the bed knife.
"Cutting Height and Blade Thickness of
Bed Knife (Bottom Blade)" (Page 4-25)
1
2
A B
3
D E
Adjustment of Rear Roller_001
1 Mower frame
2 Rear roller bracket
3 Rear roller
A Use when the reel cutter is worn out
B 3.5 - 5.0 mm (0.138 - 0.197 in)
C 3.5 - 10.0 mm (0.138 - 0.394 in)
D 10.0 - 14.0 mm (0.394 - 0.551 in)
E 14.0 - 18.0 mm (0.551 - 0.709 in)
* F 18.0 - 20.0 mm (0.709 - 0.787 in)
* Not recommended by manufacturer.
Note:
If the cutting height was the same with
settings B and C, the volume of mowing
would be larger with C since the offset
distance is larger.
LM315GC
C
F
3kws2a-008
Page 4-21