Change Of Air Cleaner - Baroness LM180E Owner's Operating Manual

4. Follow the same steps to adjust the hook
wire of left mower.
1 2
4
Wire to hook the left / right mower_001
1 Nut
2 Adjustment bolt
3 Wire (to hook the mower)
4 Right mower unit
5 Hook metal fitting
6 Bottom of the hook
Wire to hook the rear mower
1. Loosen the nuts and move the adjustment
bolt toward the center of the machine to
increase the wire tension.
2. Lower the rear mower unit, then adjust the
hook metal fitting to come into contact
slightly with the lever mounting bracket
when you grip the clutch lever completely.
3. Tighten the nuts and fix the adjustment bolt
securely.
3
2
1
Wire to hook the rear mower_001
1 Nut
2 Adjustment bolt
3 Wire
4 Hook metal fitting
5 Lever mounting bracket
Maintenance Work
3
5 6
8fihkp-001
4
5
569gs3-001
4. When the hook metal fitting returns to its
original position by spring tension as soon
as you release the lever, raise the rear
mower lifting arm and make sure that the
hook metal fitting is located closer to the
center of the machine than the upper tip of
the hook.
2
Wire to hook the rear mower_002
1 Hook metal fitting
2 Spring
3 Rear mower lifting arm
4 Hook

Change of Air Cleaner

A contaminated air cleaner element may cause
malfunction of the engine.
To maximize the life of the engine, replace the
air cleaner element at the appropriate times.
1. The timing for replacing the air cleaner
element is described below.
[1] Replace the air cleaner element in
accordance with the Maintenance
Schedule.
[2] If it is significantly contaminated, replace
it, even if the hours of operation do not
exceed the specified time.
2. Replace the air cleaner element by following
the same steps as for cleaning the air
cleaner.
"Cleaning of Air Cleaner" (Page 4-3)
LM180E
Maintenance
1
4
3
569gs3-002
Page 5-23