Adjustment Of Cutting Height - Baroness GM2810A Owner's Operating Manual

Adjustment of Cutting Height

Cutting Height Table
The adjustment range for the cutting height is
20.0 - 91.5 mm (0.79 - 3.60 in).
1 2
Cutting Height Table_001
1 Adjusting plate position 1
2 Adjusting plate position 2
3 Adjusting plate position 3
4 Adjusting plate position 4
Adjusting Plate
1
Position
Adjusting Collars
Inserted Under
Cutting Height
Adjusting Plate
(Qty)
20.0 mm
0
(0.79 in)
26.0 mm
1
(1.02 in)
32.0 mm
2
(1.26 in)
38.0 mm
3
(1.50 in)
44.0 mm
4
(1.73 in)
50.0 mm
5
(1.97 in)
56.0 mm
6
(2.20 in)
Note:
The factory default cutting height is 48.0 mm
(1.89 in).
Adjustment before Work
3 4
yizobu-001
2 3 4
Cutting Height
30.0 mm 45.5 mm 55.5 mm
(1.18 in) (1.79 in) (2.19 in)
36.0 mm 51.5 mm 61.5 mm
(1.42 in) (2.03 in) (2.42 in)
42.0 mm 57.5 mm 67.5 mm
(1.65 in) (2.26 in) (2.66 in)
48.0 mm 63.5 mm 73.5 mm
(1.89 in) (2.50 in) (2.89 in)
54.0 mm 69.5 mm 79.5 mm
(2.13 in) (2.74 in) (3.13 in)
60.0 mm 75.5 mm 85.5 mm
(2.36 in) (2.97 in) (3.67 in)
66.0 mm 81.5 mm 91.5 mm
(2.60 in) (3.21 in) (3.60 in)
Handling Instructions
Adjustment With Adjusting Collars
Adjusting collars are installed at three
locations on each mower deck.
Important
The length of grass cut off at any one time
must be no more than 30.0 mm (1.18 in).
Important
Do not cut off more than 1/3 of the grass
height.
1. Apply the parking brake, and then lower all
mower decks.
2. Stop the engine, and then remove the key.
3. Loosen the nuts securing the adjusting
collars at the three locations.
1
Adjustment With Adjusting Collars_001
1 Nut
4. Refer to the Cutting Height Table, and then
adjust the number of adjusting collars at the
three locations.
[1] To increase cutting height:
Remove an upper adjusting collar and
insert it below.
GM2810A
s8skgg-001
Page 5-17