Fuel Strainer - Baroness LM180E Owner's Operating Manual

LM180E
Handling Instructions
Supply of Fuel
Warning
Do not supply fuel above the FULL level of the
fuel gauge.
If you supply too much fuel, it might overflow
from the tank cap when you travel or work on
a slope.
Warning
Keep away from fire while refueling.
Do not smoke while refueling.
Warning
Supply fuel after stopping the engine and
allowing it to cool down completely.
Caution
Be sure not to touch hot surfaces.
If the fuel gauge, located on the fuel tank,
indicates a level close to EMPTY, supply fuel
(gasoline) at your earliest convenience.
The fuel tank capacity is approximately 6.0
3
dm (6.0 L).
Supply of Fuel_001
1
2
3
Page 4-6
3
2e4emp-020
Fuel tank
Tank cap
Fuel gauge

Fuel Strainer

Inspection of Fuel Strainer
The fuel strainer is installed near the fuel tank
and cleans the fuel that enters the carburetor.
If the fuel flow is insufficient, clean or replace
the fuel strainer as necessary.
1. Make sure that there is no fuel leakage.
2. Make sure that the fuel strainer is not
damaged or dirty.
Cleaning of Fuel Strainer
If dust or dirt accumulates in the fuel strainer,
the fuel flow will become insufficient.
Periodically clean it.
Important
Clean the fuel strainer in a clean location, free
of dust and dirt.
1. Close the fuel cock of the fuel filter.
2. Remove the strainer cup from the fuel cock.
3. Clean the filter and the inside of the strainer
cup with a solvent, such as hardly
flammable kerosene.
4. Dry with compressed air.
2
1
4
2
3
Cleaning of Fuel Strainer_001
1 Fuel cock
2 Packing
3 Strainer cup
4 Filter
1
1hecmb-002
Inspections