Chapter 12 Other Functions; Device Control - HikRobot USB3.0 User Manual

12.1 Device Control

The specific device control parameters may differ by camera models.
In the Device Control attribute, you can view device information, edit device name, reset device,
etc. The specific parameters in Device Control attribute are shown below.
Parameter
Device Scan Type
Device Vendor Name
Device Model Name
Manufacture Info.
Device Version
Device Firmware Version
Device Serial Number
Device User ID
Maximum Device Response
Time
Device Manifest Table
Address
USB3.0 Board Level Camera

Chapter 12 Other Functions

Table 12-1 Device Control Parameter Description
Read/Write Description
Read only It is the scan type of the sensor.
Read only It is the name of device manufacturer.
Read only It is the device model.
Read only It is the manufacturer information.
Read only It is the device version.
Read only It is the device firmware version and FPGA version.
Read only It is the device serial number.
Read and Device name and it is empty by default. You can set
write according to your preference.
 If User ID is empty, the client software displays the
 If you set it, the client software displays the User ID
Read only It is the device max. response time. If it has no response
after this time, the device is disconnected.
Read only It is the ID of GenICam XML that the device selects.
User Manual
·
device model + serial number.
you set + serial number.
58