Note On Stack; Note On Brk Instruction; Note On Software Break And Hardware Break; Notes On Using Address-Match Interrupts - Renesas Emulation Pod forM16C/20 Series M30200T-RPD-E User Manual

Note on Stack:

• This product uses up to 8 bytes for stack.

Note on BRK Instruction:

• BRK instruction cannot be used.

Note on Software Break and Hardware Break:

• A software break and a hardware break cannot be used simultaneously. If they are used
simultaneously, the emulation pod main unit may not work properly.

Notes on Using Address-match Interrupts:

• Do not set software breaks at the same addresses as address-match interrupts as the program may
run out of control.
• Do not set a hardware break within 4 instructions before an address at which an address-match
interrupt occurs. If you do set a hardware break in this range, the program will run out of control.
• When an address at which an address-match interrupt occurs is executed in one-step mode, the
program stops after executing the first instruction after returning from the address-match interrupt
processing.

Note on Software Reset:

• Do not use the software reset. It may not work properly.

Note on Stop and Wait Modes:

• Do not perform step execution at addresses in the stop or wait mode. It may cause communication
errors.

Note on Watchdog Function:

• Debug functions such as a single step cannot be used while using the watchdog function. Only GO
command (program execution) is possible. To use other debug functions, disable the watchdog
function.
IMPORTANT
( 14 / 32 )