Table of Contents
Advertisement
This chapter provides information about mounting the SA-100 in a rack, assigning
the unit an IP Address, and connecting it to the network. The topics discussed in this
chapter include:
"Preparing for Installation" on page -33
•
"Verifying the Contents of the SA-100 Box" on page -34
•
"Mounting the ShoreTel Service Appliance 100" on page -34
•
"Setting the IP Address Manually" on page -35
•
"Plugging the SA-100 into the Network" on page -37
•
"Connecting the Bezel" on page -38
•
"Configuring the Unit for Operation" on page -38
•
5.1
Preparing for Installation
The section lists things that are recommended and required to install a ShoreTel SA-
100.
Computer mounting rack capable of supporting 1U equipment.
•
Adequate clearance in the front and back of the rack to allow adequate
•
ventilation.
Reputable surge protector or UPS.
•
IP address to assign to the SA-100.
•
NOTE: ShoreTel recommends that you assign a static IP address to the SA-100.
IP address of the gateway that you want the SA-100 to use.
•
Subnet address that you want the SA-100 to use.
•
Computer with a terminal emulation program installed.
•
DB-9 serial cable.
•
The IP network between the main and remote sites meets the bandwidth,
•
latency, jitter, and packet loss requirements for a multisite installation.
The IP network between the main and remote site has quality of service in
•
place such that voice is prioritized ahead of data.
You have appropriate firewall considerations in place including VPN if
•
applicable.
ShoreTel 12.3
Installing the SA-100
C
H A P T E R
5
33
Advertisement
Table of Contents
