Table of Contents
Advertisement
Chapter 4: Installing the Switch on a Table
Installing the Rubber Feet on the Switch
72
The switch comes with seven rubber feet in the accessory kit. The feet,
which are reusable, are used when installing the switch on a table.
Note
Although you cannot stack the switches on top of each other, they
can be placed next to each other.
Note
The following procedure assumes that you have already reviewed
the information and performed the procedures in Chapter 2,
"Beginning the Installation" on page 49.
Warning
The switch is heavy. Always ask for assistance when moving or
lifting the device so as to avoid injuring yourself or damaging the
equipment.
To install the bumper feet on the underside of the switch, perform the
following procedure:
1. Place the switch upside down on a table.
2. Affix the seven bumper feet to the square indentations on the bottom
panel of the switch
3. Turn the switch over.
4. If the switch has a PWR250-80 DC Power Supply, go to Chapter 9,
"Wiring the DC Connector on the PWR250-80 Power Supply" on page
109.
5. After placing the switch on the table or desktop, go to Chapter 7,
"Powering On the Switch" on page 91.
Advertisement
Table of Contents
