Figure 22: Installing The Power Cord Retaining Clip - Allied Telesis AlliedWare Plus x530DP Series Installation Manual

Figure 22. Installing the Power Cord Retaining Clip
Note
The PWR250-80 and PWR1200 Power Supplies do not come with a
retaining clip.
8. To install a second power supply, repeat this procedure, starting with
step 3.
9. If you installed only one power supply in the switch, perform the
procedure in "Installing a Blank Power Supply Slot Cover" on page 68.
10. Do one of the following:
To install the switch on a table, go to Chapter 4, "Installing the

Switch on a Table" on page 71.
To install the switch in an equipment rack, refer to Chapter 5,

"Installing the Switch in an Equipment Rack" on page 73.
To install the switch on a wall, refer to Chapter 6, "Installing the

Switch on a Wall" on page 79.
To install the switch in the RKMT-SL01 sliding rack, go to Appendix

B, "Installing the Switch in the RKMT-SL01 Sliding Rack" on page
139.
x530DP Series Installation Guide for Standalone Switches
67