Parameter And Backup - Mitsubishi Electric MELSEC-Q Series User Manual

This chapter describes CC-Link IE Field Network parameters.
The CC-Link IE Field Network parameters are set for either the master station or slave
stations.
This manual describes network parameters for Simple Motion modules. For slave station
settings, refer to the manuals for the slave stations used.

7.1 Parameter and Backup

GX Works2 and Simple Motion Module Setting Tool of GX Works2 are used for each
parameter setting of the Simple Motion module.
Set the required parameter based on the target station No.
Since the modules which save each parameter setting are different, when the CPU module or
Simple Motion module is exchanged, rewrite the parameter to the exchanged module.
A programming tool used for each parameter setting and modules which backup each
parameter setting are shown below.
Item
1 to 16
Parameters
used for network
function
Parameters
used for
positioning
(Note-1)
control
Parameters
used for
synchronous
(Note-2)
control
: Valid
: Invalid
–
(Note-1): For details of parameters, refer to the "MELSEC-Q QD77GF Simple Motion Module User's Manual (Positioning Control)".
(Note-2): For details of parameters, refer to the "MELSEC-Q/L QD77MS/QD77GF/LD77MS/LD77MH Simple Motion Module User's Manual
(Synchronous Control)".
(Note-3): Parameters can be also set by a sequence program.
(Note-4): The range from the station No.1 to 4 is valid in the 4-axis module, and the range from the station No.1 to 8 is valid in the 8-axis
module.
Target station No.
(Note-4)
17 to 120
–
–
Programming tool
GX Works2
(Simple Motion
GX Works2
Module Setting
Tool)
–
(Note-3)
–
(Note-3)
–
7 - 2
Chapter 7 PARAMETER SETTING
Backup module
CPU module
–
–
Simple Motion
module
–